|Fecha||Abr 27 - 30, 2020 8:30 am - 12:00 pm|
|Proceso||Software de Diseño|
|Número de participantes||8|
Live Stream Training: Shaft and Bearing Calculation and Optimization
This training for shaft and bearing design focuses on sizing and optimization of shafts and their supports using the calculation modules in KISSsoft and learning about the underlying theory of the calculation procedures.
The training will take place on 4 consecutive days, during morning sessions that start at 8:30 am and end at 12 pm.
April 27, 2020: CET 08:30 am - 12:00 pm (Brussels)
April 28, 2020: CET 08:30 am - 12:00 pm (Brussels)
April 29, 2020: CET 08:30 am - 12:00 pm (Brussels)
April 30, 2020: CET 08:30 am - 12:00 pm (Brussels)
The target audience are engineers working in gear transmission design or manufacturing.
The objective of the first 2 morning sessions is to understand the input fields including the underlying theory, the messages created during the calculation process and how to interpret the results in graphics and reports.
The second part (Day 3 and 4) goes deeper into the sizing and optimization of shafts and bearings. The extended calculation possibilities in KISSsoft such as coaxial shaft systems, thermally critical speed and even tooth trace modifications based on shaft deflection will be explained. The determination of bearing service life and stiffness will occupy a significant part. Participants will get an insight into different service life calculation methods including inner geometry, taking into account bearing stiffness and tilting under load and even contact stress in ring material.
Registration will close on Friday 24 April 2020. Before the start of the training, participants will receive a link and information to join the training as well as a current test version and electronic training documentation.